显微镜物镜加热器 -尊龙凯时网娱乐官网

显微镜物镜加热器 objective heater 

features

temperature controlled heating band
easy installation around the objective
fits any objective on the market
compatible with the following okolab controllers:
h301-t-unit-bl-plus
uno-t-h-premixed
uno-t-h-co2
h401-t-controller
compatible with inverted and upright microscopes
self calibrationroutines with bl controllers
voltage: 24 v
power: 13 w

when should i use an objective heater
you should use an objective heater, if you:

perform oil immersion imaging with a top stage incubator
use dipping lens with an upright top stage incubator
why should i use an objective heater?
because, if you don't, sample temperature will drop due to oil contact with the cold objective, as shown in the following graph.

step 1: objective not in contact with petri 2; objective heater off.

step 2: objective in oil contact with petri 2; objective heater off.

step 3: objective in oil contact with petri 2; objective heater on, offset value 5.3°c.

during the self calibration routine, the offset value of the objective heater is progressively increased, until t2 reaches the desired set point temperature of 37.0°c.

figure 3 reports the profile of t1, t2, and of objective heater temperature during the experimental campaign described above.

    您想了解更多详细资料吗？

    请与我们联系：

    tel：021-35183767，021-54377179

         18502129044

    qq：2113136797

    微信：yuyanbio

    mail：

    欢迎您的咨询！